ST3500320 : Buffer à 0 ?

ST3500320 : Buffer à 0 ? - Disque dur - Hardware

Marsh Posté le 11-03-2008 à 19:04:00    

Bonjour,
 
J'observe de fort ralentissement lorsque j'accède la première fois à certaines applications (ex: calculatrice, bloc note, word...) le temps d'attente peut être de lors de 10s (j'ai un core2duo 6300, 2Go de Ram).
 
J'ai cherché coté virus et autres et je n'ai rien trouvé.  
Coté Disque, j'ai remarqué que HD Tune indique que mon disque possède un buffer à 0 (mes autres disques, l'indication est correcte).
 
Qu'en pensez-vous ?
 
D'avance merci.
 
Ci-dessous, mes prints de HD-Tune
 
 

HD Tune: ST3500320AS Information
 
Firmware version : SD15
Serial number    :             9QM07DB1
Capacity         : 465.8 GB (~500.1 GB)
Buffer size      : 0 KB
Standard         : ATA/ATAPI-0 - SATA II
Supported mode   : UDMA Mode 6 (Ultra ATA/133)
Current mode     : UDMA Mode 5 (Ultra ATA/100)
 
S.M.A.R.T                    : yes
48-bit Address               : yes
Read Look-Ahead              : yes
Write Cache                  : yes
Host Protected Area          : yes
Device Configuration Overlay : yes
Automatic Acoustic Management: no
Power Management             : yes
Advanced Power Management    : no
Power-up in Standby          : no
Security Mode                : yes
Firmware Upgradable          : yes
 
Partition     : 1
Drive letter  : C:\
Label         :  
Capacity      : 99998 MB
Usage         : 54.08%
Type          : NTFS
Bootable      : Yes
 
Partition     : 2
Drive letter  : D:\
Label         : Donnees
Capacity      : 138474 MB
Usage         : 82.61%
Type          : NTFS
Bootable      : No


 
 

HD Tune: ST3500320AS Health
 
ID                               Current  Worst    ThresholdData       Status    
(01) Raw Read Error Rate         119      100      6        218864924  Ok        
(03) Spin Up Time                94       94       0        0          Ok        
(04) Start/Stop Count            100      100      20       107        Ok        
(05) Reallocated Sector Count    100      100      36       0          Ok        
(07) Seek Error Rate             68       60       30       7302474    Ok        
(09) Power On Hours Count        100      100      0        295        Ok        
[#ffff00](0A) Spin Retry Count            100      100      97       0          Ok[/#ffff00]        
(0C) Power Cycle Count           100      100      20       107        Ok        
[#ffff00](B8) (unknown attribute)         100      100      99       0          Ok [/#ffff00]      
(BB) (unknown attribute)         100      100      0        0          Ok        
(BC) (unknown attribute)         100      99       0        1          Ok        
(BD) (unknown attribute)         100      100      0        0          Ok        
(BE) Airflow Temperature         57       50       45       756678699  Ok        
(C2) Temperature                 43       50       0        43         Ok        
(C3) Hardware ECC Recovered      49       33       0        218864924  Ok        
(C5) Current Pending Sector      100      100      0        0          Ok        
(C6) Offline Uncorrectable       100      100      0        0          Ok        
(C7) Ultra DMA CRC Error Count   200      200      0        0          Ok        
 
Power On Time         : 295
Health Status         : Ok

Reply

Marsh Posté le 11-03-2008 à 19:04:00   

Reply

Marsh Posté le 31-03-2008 à 21:57:54    

bonsoir,
 
Mon soucis persiste et tout porte à croire que mon problème est bien lié au disque.
J'ai effectué des traces avec bootvis et obtiens un warning :  
"Disk write caching is disabled".
 
Quelqu'un à une idée pour activer ce cache ?
 
 
 

Reply

Sujets relatifs:

Leave a Replay

Make sure you enter the(*)required information where indicate.HTML code is not allowed